|
• 0.4 - 8 mm (5/16") Cap. edgebanding thickness, min. panel width 50 mm & min. length 140 mm, panel thickness 10 - 50 mm; automatic strip & coil feed magazine with robust shear type 3 mm PVC guillotine.
• Equipped with: PLC Controls for all major functions & adjustments with internal memory storage for programmed setups.
• Equipped with Pre-Milling Section: (2) 1.64 kW (2.5 HP - 12,000 RPM) motors.
• Hot-Melt glue system (12 Min heat-up time) with Teflon-coated gluepot, digital thermostats with automatic kick-down when machine is in idle mode.
• 1" Dia. glue applicator roller; pressure section with (1) large dia. "non-stick" coated drive roller & (2) chrome plated idle rollers with pneumatic positioning.
• Workstations: Front & rear end trims (0.33 HP - 12,000 RPM motors), motors travel on (2) straight slides and pneumatic tilt 0° - 25° on horz. plane.
• Top & Bottom flush trims with "Quick Change" motors (1.0 HP - 12,000 RPM motors), digital readouts for easy setup.
• 2-Motor (0.3 HP - 12,000 RPM motors) corner rounding unit for trimming leading & trailing upper & lower edge/corners with "Fast Position", and can be used as a 2nd Top & Bottom fine trimmer as well.
• Top & bottom scrapers for 3 mm thick PVC banding, digitals for horiz. adjustments.
• Top & bottom (2,000 Watt) PVC edge hot air blowers with temperature adjustment.
• Last Station: Top & bottom buffing (0.5 HP - 2,800 RPM motors), units tilt 0° - 30°.
• Feed Speed of 39 FPM, 3 HP feed drive.
• Complete with: Microprocessor for workstations & feed speed, insulated sound enclosure over all trim stations with triple split dust hood, industrial lights and viewing windows.
• Extendible side panel support rail, 12 KVA - 240 Hz digital frequency inverters.
• Includes: Used tooling on all workstations. - Electric: 230 V, 60 Cy, 3 Ph. [EO-0111452]
Unit sold as new in June '07 has seen very little use!
|
:61/0
