|
http://www.disco.co.jp
(Specification Summary)
Workpiece size (mm) : Max. φ300
X-axis
Cutting range(mm) : 310
Cut speed(mm/s) : 0.1 - 600
Y1/Y2-axis
Cutting range(mm) : 310
Index step(mm) : 0.0001
Index positioning accuracy(mm) : 0.003/310
(Single error) 0.002 or less/5
Scale resolution(mm/s) : 0.0001
Z1/Z2-axis
Max. stroke(mm) : 14.7 (for 2" blade)
Moving resolution(mm) : 0.00005
Repeating accuracy(mm) : 0.001
Max. blade size(mm) : φ58
θ-axis
Max. rotating angle(deg.) : 380
Spindle
Output(kw) : 1.2 at 60,000 min
Rated Torque(Nm) : 0.19
Revolution speed range (min) : 6,000 - 60,000
Applicable tape frame : 2-12
Utilities
Power supply : 200 - 240 VAC+/-10%, 3Phase(50/60Hz)
(For other than the above voltages, a transformer is necessary.)
Power consumption
When processing(kW) : 2.2 (forreference)
During Warm-Up(kW) : 1.8 (for reference)
Air pressure(MPa) : 0.5 - 0.8
Average air consumption
during operation(L/min, ANR) : 189.0 (for reference)
Clean air pressure(MPa) : 0.5 - 0.8
Average dean ar consumption
durhg operation(L/min, ANR) : 65.0 (for reference)
Cutting water, water curtain and other
Pressure(MPa) : 0.2 - 0.4
Consumption flow rate(L/min) : Cutting water,: 12
Water curtain: 1
Other: 1
Cooling water
Pressure(MPa) : 0.2 - 0.4
Consumption flow rate(L/min) : 3.0 at 0.3 MPa
Exhaust duct capacity(m3/min) : 5.0
Machine size (wxdxh, mm) : 1,200x1,550x1,800
Machine weight(kg) : Approx. 2,050(without transformer for overseas use)
Approx. 2,150
(with transformer for overseas use)
Environmental conditions
- Use clean, oil-free air at a dew point of -15 'C or less.
Use a residual oil: 0.1 ppm 1 Wt/Wt.
Filtration rating: 0.01 Lim/99.5% or more.
- Keep room temperature fluctuations within +/-1'C of the set value.
Set value should be between 20 - 25'C.
- Keep cutting water and cleaning water 2'C above room temperature
(fluctuations within +/-1 'C).
- Keep spindle cooling water the same as room temperature
(20 - 25'C, fluctuations within +/-1'C).
- The machine can be equiped with CSP software for the QFN spec. If you intrested, please contact with us. We can provide good support for your production and you anywhere.
|
:179/6
