|
Cincinnati Floor type Horizontal Boring Mill
Serial no.: 66-428-R-833-1 X (Cross Travel) Axis travel = 8,000 mm
Y (Vertical Travel) Axis travel = 2,134 mm
Z Axis travel = 914 mm Feed rates:
Manual Mode – X,Y,Z, = 0.5 - 150 I.P.M.
Numerical Control Mode – X,Y,Z, = 0 - 150 I.P.M.
Rapid Mode – X,Y,Z, = 150 I.P.M. Spindle Speeds: 18 – 1800 R.P.M.
Bar Nose Dia: 152.4 mm
Bar Travel (Z Axis): 914 mm
Intermediate Spindle Dia.: 302.4 mm
Quill Dia.: 419 mm
Quill Travel (Z Axis): 914 mm Ranges:
Intermediate Spindle face to Carrier face: 1.500” – 37.500”
Bar face to Carrier face: 5” – 41”
Bar centerline to top of work table: Max 78”
Bar face (retracted) to edge of work table: Min 7” Including:
Work mount angle plates:
(1) 9’ high x 9’ wide vertical face with T-Slots x 4’ deep base plate
(1) 6’ high x 6’ wide vertical face with T-Slots x 4’ deep base plate Work Tables:
(1) 8’ Deep x 10’ wide T-slotted – pit mounted
(1) 6’ Deep x 10’ wide T-slotted on 8’ x 10’ base – surface mounted Numerical Control:
Delta Tau retrofit 1995 PMAC Operating System with Paradym 3.1 Industrial Control
Retrofitted in 1995
|
:88/3
